ETI 50240161 Manual De Instrucciones

nOTe: Keep your receipt and these instructions for proof of
purchase.
WarninG: Shut off the power at the circuit breaker or fuse panel
before removing the old fixture, ballast, or fluorescent tubes.
If you are unfamiliar with electrical installations, we recommend you
contact a qualified electrician to do the installation.
INSTALLATION
nOTiCe: Select a suitable location that can support the weight of the
fixture. Determine the method of mounting before beginning installation.
Shut off power at the electrical panel before beginning the
1
installation.
Remove existing fixture and set aside to recycle in accordance with
2
local requirements.
SuSPeNSION MOuNTINg INSTALLATION
Driver Box Cover Plate
A
Knock Out Hole
Remove the driver box cover plate and punch out
3a
the knock out hole.
Feed the 1/2in or 3/4in conduit (based on local
4a
electrical code) through the knock out hole.
D
SurfAce MOuNTINg INSTALLATION
Driver Box Cover Plate
A
Remove the driver box cover plate from the fixture
3b
housing.
Connect the fixture housing to the mounting
6b
bracket and secure with 2 screws on each side.
Use and Care GUide
Linear HiGH BaY Led
Ground Wire
5a
6a
Make the electrical connections:
8a
• Feed wires from the fixture through the conduit.
• Black wire to black wire.
• White wire to white wire.
• Ground wire to ground.
• If a 0-10v dimming circuit is available, connect the purple and pink
wires from the fixture housing to the dimming wires from the flexible
pipe. If not, cover wires with wire connectors.
• Use wire connectors to cover the wire connections and wrap with
electrical tape.
Knock Out Hole
4b
7b
Model # 50240161 Part # HBL-2FT-12000LM-8-50K-MV-LVd
50240261
50241161 HBL-2.75FT-24000LM-8-50K-MV-LVd
PAckAge cONTeNTS
Part Description Quantity
A Fixture Housing
B Metal Chain
C S-Hook
D Wire Connector
E V Clip
AcceSSOrIeS AvAILAbLe fOr PurchASe:
Part Description
F Mounting Bracket
H 1/2" Downrod Mount / 7mm Threaded
Downrod Mount
I Tandem Mounting Bracket
C
E
B
Connect the V Clips to each end of the
fixture housing.
Connect the S-Hooks to the V Clips and
then connect the metal chains to each
S-Hook. Use pliers to pinch the S-Hooks
closed.
Electrical Box
F
Feed wires from the electrical box through the
mounting bracket. Use the electrical box screws to
secure the mounting bracket to the electrical box.
CC
Make the electrical connections. See step 8a and
9a in the Suspension Mounting Installation section.
HBL-2FT-18000LM-8-50K-MV-LVd
A
1
2
2
D
5
2
Quantity Model #
1 95024016101
(Including F&G)
1 95024016103
(Including F&G&H)
1 95024016102
Install hooks (not included) into the ceiling
7a
and attach the metal chains. The fixture
must hang 2.5ft. from the ceiling.
Tuck wires inside the driver box and reattach
9a
the driver box cover plate.
10a
Restore power at the electrical panel.
Attach the mounting bracket cover plates
5b
to the side of the mounting bracket.
Restore power at the electrical panel.
8b
Certification # 50240161
50240261
50241161
B
E
F
H
I
G
C
G