Horizon Fitness EX-59 Manual Del Propietário página 5

ASSEMBLY STEP 3
CONSOLE MAST
CONSOLE CABLE
PRE-INSTALLED BOLTS
MAIN FRAME
NOTE: Be
careful not
to pinch any
wires while
attaching the
console mast.
CRANK
PEDAL ARM
GUIDE RAIL
PEDAL ARM WHEEL
8
EX-59-CE5.2-OM-rev1.2.indd 8-9
HARDWARE BAG 3 CONTENTS :
WAVY WASHER (G) FLAT WASHER (H) SPRING WASHER (I)
22.5 mm 20 mm 15 mm
Qty: 2 Qty: 2 Qty: 2
Open hardware bag 3.
A
Carefully pull the console cable through
B
the console mast using the twist tie located
inside the console mast.
C gently slide the console mast onto the
main frame and attach console mast to
main frame using pre-installed bolts.
Slide wavy washer (g) over cranK
D
followed by pedal arm as shown. Rest
pedal arm wheel on guide rail.
Attach the pedal arm to the cranK using 1
E
flat washer (h), 1 spring washer (i)
and 1 bolt (J).
WAVY WASHER (G)
FLAT WASHER (H)
Repeat steps D–E on the opposite side of the
F
SPRING WASHER (I)
elliptical.
BOLT (J)
ASSEMBLY STEP 4
BOLT (J)
20 mm
Qty: 2
BOLT (M)
SPRING WASHER (N)
FLAT WASHER (O)
PEDAL ARM BRACKET
HARDWARE BAG 4 CONTENTS :
FLAT WAVY
WASHER (K) WASHER (L)
27 mm 29 mm
Qty: 4 Qty: 2
SPRING WASHER (N) FLAT WASHER (O)
15.4 mm 20 mm
Qty: 2 Qty: 2
Open hardware bag 4.
A
Slide 1 flat washer (K), 1 wavy
B
washer (l) and another flat washer
(K) onto the lower linK arm.
Slide the lower linK arm into the
C
pedal arm bracKet.
Attach the lower linK arm to the
D
FLAT WASHERS (K)
pedal arm bracKet using 1 flat
WAVY WASHER (L)
washer (o), 1 spring washer (n)
LOWER LINK ARM
and 1 bolt (m).
Repeat steps B–D on the opposite side of
E
the elliptical.
BOLT (M)
20 mm
Qty: 2
9
7/6/10 4:33 PM