Publicidad
Idiomas disponibles
Idiomas disponibles
TECHNICAL DATA
Model
Viewing are
Weight, with external controls
Open state shade
Closed state shade
Shade adjustment
Sensitivity adjustment
Delay adjustment
Grinding mode
Switching time at 23°C
TIG
Clearing time
UV/IR protection
Temperature range
TIG detection
Energy supply
REPLACING THE EXTERNAL PROTECTIVE PLATE
Place the helmet face down. Tilt the headgear unit the sweatband is closer to the top of the
1.
helmet. Now undo the thumb screw turning it anti-clockwise (Fig. 1), remove the thumb screw and put
to one side.
Lift the retainer frame upwards until it is at an angle of roughly 45 degrees (Fig 2). The gently
2.
pull the frame towards the chin of the helmet this will release the hooks (Fig. 3). Once the frame is free
leave inside the helmet but put to one side.
Remove the old protection plate by pushing from the outside of the helmet. Insert the new
3.
protection plate ensuring it is square in the recess. Locate the retainer frame hooks into the locators in
welding helmet. Once located lower the frame and reinsert the thumb screw and tighten.
During assembly of the helmet and auto-darkening fi lter, or during the replacement of the protection
plates, make sure that all parts are fi rmly in place thus preventing any light from entering the helmet.
Should there still be any light entering, repeat the procedure until the problem is eliminated, otherwise
the helmet must not be used for welding.
Before placing the new protection plates, always remove the protection layers from both sides. (Fig 5)
Translight Plus® HEADGEAR REMOVAL AND REPLACEMENT
1. Remove headgear by unscrewing the headgear nuts (C) and fl exing the helmet shell off of the
headgear screws (A) (Fig. 6).
2. Insert the headgear (A) into the helmet shell (B) as shown in the fi gures below.
3. Push the screws (A) through the openings in the helmet shell. Engage the small tilt positioning
pins (E) into the desired tilt positioning holes in the shell.
4. Tighten a headgear nut (C) onto each screw.
5.
Adjust the headgear to optimize comfort and fi t. The perimeter of the fl exi-seal should touch
your face and extend below your chin.
6.
Adjust the length of the top strap so the headgear rests at a comfortable position around your
head (Fig. 7).
a
solar cells / CR2032 Lithium battery
555
3.86" X 3.23" (98 X 82mm)
1.39 lbs (632g)
3
5-8 / 9-14
yes / internal / digital
yes / internal / digital
yes / internal / digital
yes / internal / external
1/ 25,000 sec
>2 amps
0.1 – 0.9 s
UV14 / IR14
-5°C / +55°C
enhanced
GB 6
Publicidad
