Publicidad
Idiomas disponibles
Idiomas disponibles
LARGE BOTTOM DRAWER
Assemble slides to the Large Bottom drawer by attaching
2 of the inside arms of the drawer slide that you removed
to the bottom rail of either side of the outside of the
drawer. Attach with 8 bolts (T) - 4 on each side, as shown.
Finger tighten until all bolts are in place. When bolts are
all in place-tighten them (do not over tighten). Make sure
the solid edge of the drawer slide is at the front of the
drawer and the end with the cutout is at the back of the
drawer.
DRAWER INSTALLATION
MEDIUM TOP DRAWER
This step is easier with two people.
Note that the medium drawer goes on top.
To install the drawer into the cabinet, extend the ball
bearing slides that were install inside the cabinet, so they
stick out beyond the front edge of the cabinet.
With one person on each side of the drawer. Lift the
drawer into position so the inner slide (attached to the
drawer) lines up with the ball bearing slide inside the
cabinet. Make sure they are seated properly. Then slide
the drawer into place. You should hear a small click when
the slides are engaged. Close the drawer fully (the first
time will require a firm closing of the drawer) and then pull
the drawer open to make sure they are properly engaged.
The drawer should not pull completely out.
If assembling a 3 drawer unit repeat above drawer
instillation for remaining 2 large drawers. Note that the
large drawer with the slides on the top rail goes in the
middle drawer location. The remaining large drawer with
the slides on the bottom rail goes in the bottom drawer
location.
To install large drawer divider (ML) or medium drawer
divider (MM) the notches on the dividers must line up
with the tracks on the inside of the front and back panels.
Once the dividers are lined up slide them side to side until
in the desired location. Once in location press down to
secure into slot.
Repeat for remaining dividers.
11 | www.bluesk youtdoorliving.com
Publicidad
