Publicidad
Idiomas disponibles
Idiomas disponibles
Empty drawer before removing it from the cabinet. It is easier to
remove the drawer with two people. To remove the drawer, pull
the drawer open enough to fully extend the slides. Push up on the
black release lever on one side of the inner slide, while pushing
down on the black release lever on the other side of the drawer.
While holding the levers in these positions, pull the drawer outward,
towards you, until it is released from the drawer slide.
REFER TO DRAWER INSTALLATION TO RE-INSTALL
DRAWERS.
DETAIL AND FINISHING
With the cabinet assembled and in place, check to make sure
it is still level. Adjust the leveling feet if need. This is a two
person job, one to tip the cabinet back slightly and the other
X4
X4
to adjust the leveling feet.
The cabinets can also be bolted together through 4 locations
on each of the side panels using 4 bolts (P) and 4 nuts (Q).
If the cabinet are not bolted together or if it is a stand alone
cabinet there are caps (H) include to fill the holes and reduce
the chance of moisture getting into the cabinet.
FOR CABINETS WITH DOORS:
If the cabinet doors do not line up, please see instruction
below.
The hinges can easily be adjust up or down by loosening the
hinge screws attached to the front edge of the frame using
provided hex key. Slide the door up or down until the doors
are aligned and then tighten the screws.
12 | www.bluesk youtdoorliving.com
Publicidad
