Publicidad
Idiomas disponibles
Idiomas disponibles
BASIC CABINET BODY
ASSEMBLY
LEVELING THE BASE
Now that you have picked your location, attach the leveling
feet (C) to the underside of the cabinet base (B). Move the
nut down to the bottom of the leveling feet. We recommend
you start with the leveling foot at it's lowest position and then
you can easily adjust the leveling foot when the base is in
place.
Place the base in the desired location, and make sure it is
level using a 4' to 6' level. On the front to back leveling, have
the cabinet slightly lower in the back to allow for moisture to
drain off the back.
NOTE: The hole location for electrical cords is in the back of
the base of the cabinet. Adjust the leveling feet if needed.
Place the large plastic cap (F) in the hole in the back of the
cabinet base.
CABINET BODY TO BASE
ASSEMBLY
(ASSEMBLY IS THE SAME FOR ALL CABINETS)
2 DOOR CABINET IMAGE IS SHOWN AS EXAMPLE ONLY
With two people, lift the cabinet body (A) upright with the
sticker inside pointing up. One person should hold onto the
front edge of the cabinet (do not lift by the doors) while the
other pulls out the back of the cabinet so that it is no longer
folded.
With two people, lift the cabinet by the back and front edges
of the cabinet frame, place the cabinet on top of the base that
has been leveled. Make sure the hole for the electrical cords
is in the back of the cabinet. Make sure the cabinet body is
properly seated on the base.
The cabinet body has a snug fit to the base, you may need
to use a flat head screw driver to guide one side into place
or use a rubber mallet to tap it into place so it sits flat on the
base.
6 | www.bluesk youtdoorliving.com
Publicidad
