Dealer Service And Adjustment; Dealer Service Introduction; Critical Maintenance Tips; C.CLeaning - Sunrise Medical Breezy Ultra 4 Manual De Instrucciones

B REEZ Y UL TRA 4
The owner of this chair is responsible for making sure that it has been setup and adjusted by a trained service
professional under the advice of a healthcare advisor. Service and/or adjustments should only be done with the
advice of a healthcare professional. Always use parts and/or accessories that have been recommended and
approved by Sunrise Medical when servicing this chair.
A. DEALER SERVICE INTRODUCTION
1. At least once per year, this chair should have a complete inspection, safety check, and regular service
made by an authorized dealer. The tools at right are a good start for proper maintenance.
2. Torque settings– A torque setting is the optimum tightening which should be made on a particular fasten-
er. It is important to use proper torque settings where specified. When not specified, torque settings
should be 60 in-lbs.
3. If you have discovered a worn, bent, or damaged part, repair or replace them with recommended parts
before returning this chair to service..
4. All major maintenance and repair work should be done by the authorized dealer.
B. CRITICAL MAINTENANCE TIPS
1. Torque settings:
A torque setting is the optimum tightening which should be made on a particular fastener. It is important to use
proper torque settings where specified. When not specified, torque settings should be 60 in-lbs
2. Dealer Service and Adjustment Reference materials:
Go to www.sunrisemedical.com for parts manuals, instruction sheets, and instructional videos that will aid in the
repair of the Breezy Family of wheelchairs.
C. CLEANING
1. Paint Finish
a. Clean the painted surfaces with mild soap or detergent.
b. Protect the paint with a coat of non-abrasive auto wax.
2. Axles and Moving Parts
a. Clean around axles and moving parts with a slightly damp (not wet) cloth.
b. Wipe off or blow away any fluff, dust or dirt on axles or moving parts.
c. DO NOT USE 3 in 1 oil, or WD-40 ® for lubrication. Only use Teflon based Lubricant when working on
this wheelchair.
D. REAR AXLES
1. Seat Height Adjustment
Seat height is adjusted by repositioning the axle(A) vertically in one of the predrilled holes(B) or (C) in the axle
plate.
NOTE– A front caster adjustment should be made to correspond with any change in seat height.
E. REAR WHEEL AXLE NUT ADJUSTMENT
Tight axle sleeves should be maintained for proper performance of the wheelchair.
a. To adjust the axle (D) you will need a 19mm or (3/4") wrench (E) to turn the outside axle nuts (F).
b. You will also need an 11mm or (1/2")wrench to lodge the ball bearings (G), on the opposite end of the
axle, and prevent the axle from turning.
c. Turn the outside axle nut (F) clockwise to tighten.
d. There should only be zero to .25mm of play.
e. Check to make sure that the quick-release button (H) is flush with the edge of the wheel.
MK-100078 RevA
WARNING
27
28
29
IX. DEALER SERVICE AND ADJUSTMENT
18
TOOLS YOU WILL NEED
1. Metric Hex key set
2. Metric Open-end Wrench set
3. Torque wrench
4. Metric Hex bit Socket set
5. Phillips and Flat screwdrivers
G
F
H
27
28
B
29
E