Thermador Masterpiece Serie Guia De Instalacion página 26

en-us Installing the ovens into the cabinet
Note: All adjustments can be made with the lower hinge
3.
only. The upper hinge is fixed in place and cannot be
adjusted.
Use a T-20 star bit screwdriver to loosen the three (3)
screws on the lower hinge by one to two full turns.
8.3 Side hinge door troubleshooting guide
Issue Additional information
The door does not The side edge of the inner
pull itself closed and door, on the handle side of
is difficult to open. the door, appears to make
contact with the appliance's
side trim.
The door does not Very little force is required to
stay closed. pull open the door.
26
Use a cross head screwdriver to turn the cam
4.
left to adjust the hinge position in the desired direction.
Note: 1 mm of hinge movement (left or right) will move
the door up or down approximately 1.5 mm at the door
catch.
Re-tighten the screws, then close the door to test. Be
5.
careful not to overtighten.
Check for proper door alignment. Repeat adjustment
6.
procedure as necessary.
Explanation
The installation is causing
the side trim to be pushed
too far inward.
The door catch mechanism
inside the door has
inadvertently tripped while
the door was open.
Suggestion
Check the installation of the
¡
appliance in the cabinetry. Try
moving the appliance in the
cabinet towards the side of the
hinges to allow the interfering side
trim to open up.
Adjust the location of the side trim
¡
screws to hold the trim away from
the door.
Check that the cabinet opening is
¡
not too narrow. Widen the cutout
as necessary.
To reset the mechanism, close
¡
the door completely and while
closed, push in firmly on the door
handle until the mechanism
resets.
Open the door to test.
¡
right or