Thermador Masterpiece Serie Guia De Instalacion página 5

2 Before you begin Before you begin
Read these instructions before you begin to install your
Before you begin
appliance.
2.1 Combination installations
For combination installations with other Thermador
products (i.e. cooktop over oven, etc.), refer to the
Approved Combination Guide located in the manual kit or
on our website for additional clearance requirements for
your specific installation.
2.2 Parts included
After unpacking all the parts, check for any damage in
transit and for completeness of delivery.
Appliance
¡
6 x cross-head screws
¡
2.3 Tools and parts needed
Prepare these tools and accessories before you start to
install your appliance.
Pencil
¡
Measuring tape
¡
Level
¡
T20 star bit screwdriver
¡
Cross head screwdriver
¡
Drill with bit 1/8"
¡
Knife
¡
Safety gloves
¡
2.4 Power requirements and grounding
The outlet must be properly grounded in accordance with
all applicable codes.
Package removal 3 Package removal
Protect any finished flooring before you move the oven.
Package removal
3.1 Removing the packaging from built-in
single and double ovens
Cut the box straps.
1.
Open the top of the carton and remove the top wood
2.
frame.
Remove the carton by lifting it up and off the unit.
3.
Alternatively you can carefully cut along the cut line on
the back left side of the carton with a blade shorter than
3/4" (20 mm).
Place the unit in front of the cabinet where it is to be
4.
installed. The unit should be in line with the cabinet
cutout.
Leave the unit on the packaging base until it is ready to
be lifted into the cabinet cutout.
Remove all internal protective packaging, racks,
5.
accessories, and instruction manuals from the oven
cavity.
Remove the packaging brackets.
6.
With a T-20 star bit screwdriver, remove the screws
‒
that go through the slotted holes in the mounting
brackets on the left and right side.
Do not remove any additional screws from the oven.
‒
The oven is released from the packaging base.
a
The brackets remain in the packaging base.
a
Leave the appliance on the packaging base until you lift
7.
it into the cabinet cutout or onto the lower oven.
4 Installation requirements
Installation requirements
Read these instructions to prepare the installation space
Installation requirements
for your appliance.
4.1 Appliance weight
The cabinet base must support the weight of your oven as
stated in this table.
Oven type
Steam oven, single
Steam oven, double
Conventional oven, single
Conventional oven, double
Combination oven
with microwave or speed
oven
Triple oven
Storage drawer
Before you begin en-us
Weight
192 lbs
(87 kg)
328 lbs
(149 kg)
214 lbs
(97 kg)
328 lbs
(149 kg)
287 lbs
(131 kg)
364 lbs
(166 kg)
80 lbs
(37 kg)
5