ADURO Asgard 1 Manual De Usuario página 25

2.3 Connection to a brick chimney
If the stove is being connected to a brick chimney, a curved flue pipe should be used. After measuring, a
hole is made in the chimney in which the pipe sleeve is placed, and stove mortar is used to seal it in place.
The stove is placed in position and the flue pipe is put in place. A thin gasket is placed between the flue pipe
and the pipe sleeve to seal the joints. The flue pipe should protrude into the pipe sleeve but must not block
the opening in the chimney (see the illustration below). You may benefit from putting a slim gasket between
the flue outlet on the stove and the flue pipe.
You may benefit from putting a slim gasket between the flue outlet on the stove and the flue pipe.
Important safety information:
•
The wood burning stove will become warm during use and therefore it should be treated with all
necessary caution.
•
Never keep easily combustible fluids such as petrol in the vicinity of the wood burning stove.
•
Never use easily combustible fluids to light the fire in the wood burning stove.
•
When lighting a fire and adding new wood logs, it is important to get the fire burning fast. If the fire
does not start quickly and wood only smoulders, it can cause strong smoke formation and in worst
case cause an explosive ignition of the flue gasses, which can damage the stove.
•
Never empty the ashpan when the wood burning stove is warm. Embers may still be found in the
ashpan for up to 24 hours after the fire has gone out. Please wait to empty the ashpan until you
are sure that there are no embers in the ash.
•
The door should be kept closed while the wood burning stove is in use. While lighting the fire, the
door can stand ajar for the first few minutes.
•
When putting logs in a hot stove, you must always open the primary air intake and make sure that
the wood ignites within 2-3 minutes. If the wood does not ignite, add some ignition products, and
ignite them manually. Please make sure that the flames are burning steadily for the first 10
minutes before you leave the stove.
•
In the event of a chimney fire: Close all the dampers on the wood burning stove and call the fire-
fighting service.
3.1 Damper
The stove is equipped with air dampers for regulation of the primary and secondary air supply. The primary
air is used at the beginning to get the fire going, and the secondary air keeps the fire burning evenly. The
tertiary air ensures that flue gasses are burned and is not adjustable. You must always add secondary and
tertiary air, while firing the stove.
3. Lighting the stove
25