Sagi ME70LTR Manual De Uso E Instalación página 153

Cold stores are equipped with door opening to the right.
When inverting door opening, proceed as follows:
•
Rotate the instrument panel on the side heads by removing the "F" screw.
•
Remove the two fixing screws of the bracket "A" and the holding screw of the hinge "B".
•
Remove the upper door ; disassemble the hinge "B" and the component "E", then reverse their
assembly.
•
Remove the component "C" and install it on the opposite side of the door.
•
Remove the middle bracket "G" and re-install it in its specific seat on the opposite side.
•
Remove the lower door ; disassemble the hinge "B" and the component "E", then reverse their assembly.
•
Move the lower door micro to the opposite side using the specific hole.
•
Remove the lower bracket "D" and re-install it onto the component "B" located on the lower door.
•
Set the lower door introducing the component "E" in the pin of the bracket "G".
•
Fix the bracket "D" tightening the fixing screws thoroughly.
•
Place the bracket "A" on the component "B" located on the upper door.
•
Set the upper door introducing the component "E" in the pin of the bracket "G".
•
Fix the bracket "A" tightening the fixing screws thoroughly.
•
Before tightening the bracket screws, check the hinge height (12 mm approx.) and the door
perpendicular position with respect to the structure.
•
Replace the instrument panel.
NOTE: Keep the door closed when removing and installing the brackets.
INVERTING THE 1/2 DOOR
35