Emmaljunga Sento MAX Manual De Instrucciones página 35

Chassis
1) Assembly of the chassis
1. Slide the safety handle all the way to
the side (See arrow 1 located on the
safety handle). Maintain the position
and rotate the safety handle all the
way (See arrow 2 located on the safety
handle)
2. Unfold the rear legs
3. Press the bar in the middle of the
chassis until you hear a clear "click".
Make sure left and right side "Click" in
properly. Make sure that you now see
the closed padlock. If the open padlock
is visible, the chassis is NOT locked.
WARNING
• ALWAYS check before use that the
chassis is locked. The closed padlock
will be shown.
• If the open padlock icon is visible,
press down on the metal bar, the
chassis locks and you will hear 'click'
• Never use the stroller if the symbol
with the open padlock is visible.
4. Pull out the telescopic handle. Make
sure that the handlebar is at the same
height on both sides before you lock
into position.
5. Lock the Telescopic locks on both
sides. Make sure the Telescopic locks
are properly locked with a "click".
6. Press the handle buttons on the
inside of the handlebar and unfold
the handle. Make sure they click into
position.
WARNING
• There must not be a child in the pram
when it is folded or unfolded
• Avoid having children in the vicinity
when the pram is folded or unfolded.
• Ensure that children are kept away
from all moving parts of the pram to
avoid risk of injury.
Sento MAX, Sento LUX V 1.1
2) Rear Wheels
Assemble of the rear wheels
1. Assemble the locking clip on the rear
wheel. Place the clip in open position.
2. Put the wheel shaft in position and lock
by the clip.
3. Assemble the rear wheel cover cap.
Assemble the rear wheel to the chassis
4. Wipe dirt from the wheel shafts before
you put on the wheels. Make sure the
rear wheel lock is in the open position,
marked red.
5. Place the wheel on the chassis and lock
with the wheel lock.
WARNING
• Ensure the wheel shaft is locked with
the locking clip before the wheel
cover cap is attached.
• The wheel cover cap must be
attached before use
• Check that the rear wheel is attached
to the chassis properly by pulling the
wheel. Repeat on both sides. The red
mark must not be shown.
Remove the rear wheels from the
stroller
6. Open the rear wheel lock and remove
the rear wheel.
Deassemble the rear wheel
7. Remove the wheel cover cap by
pressing the hooks inwards.
8. Place the locking clip in open position
and remove the wheel shaft.
3) Front Wheels
Assemble of the front wheels
1.Press the front wheel lock and push
the front wheel in place. Release the
lock and make sure the front wheel
is attached to the chassis properly,
by pulling the wheel. Repeat on both
sides.
2. Press the front wheel lock and remove
SE
SE
2-5
11-28
EN
2-5
29-46
DE
2-5
47-66
DK
2-5
67-84
FI
2-5
85-102
NO
2-5
103-120
CZ
SE SE
2-5
121-137
CZ
EE
2-5
18-19
2-5
138-155
EE
ES
2-5
2-5
20-21
156-174
ES
LT
2-5
2-5
22-23
175-192
LT
LV
2-5
2-5
24-25
193-210
LV
PL
2-5
2-5
26-27
211-229
PL
2-5
28-29
35