MSW Motor Technics MSW-PLT-W20 Manual De Instrucciones página 36

aa. Device ON/OFF button
bb. Buttons for setting the ignition level
cc. Temperature level setting buttons
dd. Value increase/decrease button for a given parameter
ee. Button to set the operating frequency of the pellet feeder
ff. Button to set the speed of the exhaust fan
hg. Button for simplified changes in timer mode
3.3.2 Before starting up for the first time
IMPORTANT: the stove may give off an unpleasant odor when it is first used - the paint inside will burn
out. This is normal and is not a product defect - the unpleasant odor should pass over time.
Put the pellets into the furnace by pouring them in (it is not necessary to fill the hopper
•
completely).
• Set the red power switch to the ON ("I") position - it should light up, which means that the
stove has power and started working.
• After start-up, the stove system will go into the self-diagnosis procedure and if successful,
the device is ready for operation.
3.3.3 Starting and working
Please check if the burn pot and ash box are in proper position or not, if not, adjust them to right
position.
Turning the device on/off
The stove is turned on and off by pressing the button
Press to enter automatic ignition mode, the display will show:
Press again, the device will enter shutdown mode and the display will show:
When the shutdown process begins, the device will automatically remove the ash. Then the same
message will appear on the display as before the first start:
EN
.