MSW Motor Technics MSW-PLT-W20 Manual De Instrucciones página 39

Setting the power level
Press 2 times to enter power level settings. When the icon
power level (0-4), level 0 is automatic operation mode (setting recommended by the manufacturer),
the stove will automatically adjust the power level according to the set temperature. The display
shows as follows:
Pellet feeding settings
Press 3 times to go to pellet feeding settings. When the icons
simultaneously, you can adjust the pellet feeding time depending on the different quality pellets.
The amount of pellets fed can be adjusted in the range of 1-5 degrees by pressing the
button. Level 3 is factory set. Increasing or decreasing the level by 1 will change the feeding time by 1
second accordingly. The display will show as follows:
When the water temperature in the device reaches 85°C, the stove will turn off automatically and E4
will appear on the display.
Clock setting
flashing on the display at the same time, press ◀ or ▶ to set the day of the week, hour and minutes.
Press and hold 5 times to access clock settings. When
Error codes
E1 - room temperature sensor (NTC) does not work
EN
,
is flashing, you can set the
, flash
or
� �
, are