GE 22 Manual Del Propietario E Instalación página 5

About the temperaturecontrols, gecom
HOLO 3 SECS
The temperature controls are preset in the factory at 37°F for the
refrigerator compartment and O°F for the freezer compartment.
Allow24 hours for the temperature to stabilize to the preset
recommended settings.
The temperature controls can display both the SET temperature
as well as the actual temperature in the refrigerator and freezer.
The actual temperature may vary slightly from the SET
temperature based on usage and operating environment.
Setting either or both controls to OFF stops cooling in both the
freezer and refrigerator compartments, but does not shut off
electrical power to the refrigerator.
NOTE: The refrigerator is shipped with protective film covering
the temperature controls. If this film was not removed during
installation, remove it now.
To change the temperature, press and release the
WARMER or
COLDER pad.
Tile SETlight will come
on and tile display will show tile set temi)eramre.
To change the temperature, tap either the
WARMER or COLDER pad until tile desired
telnl)erature is displayed. ReflJgerator telnl)eratures
can be a(!justed between 34°F and 44°F and tile
fl'eezer teinperatures can be ac!justed between
-()°F and +6°E
Once the desired temperature has been set,
tile temperature display will return to tile actual
refi_gerator and fl'eezer teilll)erattlres after 5
seconds. Several a(!justments may be required.
Each time you
a(!just controls,
allow 24 hom_ fin" the
refl_igerator to reach the temperature you have set.
To turn the cooling system off, tap the WARMER pad
fin" either tile refi_gerator or tile fl'eezer tmtil tile
display sho_:s OFF. To turn the unit back on, press tile
COLDER pad fin" either tile refrigerator or fl'eezex:
The SETlight will ilhmfinate on the side w)u
selected, Then press the COLDER pad again (on the
side where the SETlight is ilhmfinated) and it will
go to the preset points of O°Ffi)r the fl'eezer and
37°Ffl)r
tile refl_igeratox: Setting either or both
controls to OFFstops cooling in both the fi'eezer
and refl_igerator compartments, but does not shut
off electrical power to tile reli_igerator
Locking the Controls (on some models)
This feature allo_vs w_u to lock tile controls
so the settings cannot be changed.
To lock the controls:
@ Set tile controls to tile desired settings.
Press and hold the lock pad fin.
3 seconds.
When the controls are locked, the indicator
light will come on and the control settings
will not be displayed.
To unlock the controls:
Press and hold tile lock pad fin" 3 seconds.
_Mter Âmloc!dng tile controls, tile settings
will be displayed, the lock indicator light
will go out and the settings can be changed.