Publicidad
Idiomas disponibles
Idiomas disponibles
FINAL INSTALLATION
4.
Insert the blade assembly through the slot
in the housing. Align the holes from the
blade arm (K) to the holes from the fan
motor assembly (F), and secure the blade
assembly in place with screws and lock
washers (DD) provided.
Repeat this procedure with the remaining
blades assembly.
Hardware Used
Blade Arm Screw
5.
The fan motor assembly is shipped with
packing mount to prevent movement during
transportation. Remove the packing mount
from the switch housing mounting ring and
discard prior to attaching the switch
housing (G).
6.
Reinstall the two switch housing mounting
screws (O) that were just removed back to
the switch housing mounting ring. (Do not
tight.)
While holding the switch housing (G) under
the fan motor assembly (F), snap together
the wire connection plug with the 9-pin plug
from the switch housing (G).
Place the key holes on the switch housing
(G) over the two screws (O) previously
loosened from the mounting ring. Turn the
switch housing (G) until the switch housing
(G) locks in place at the narrow section of
the key holes. Secure by tightening the two
mounting screws (O) previously loosened
and the one (O) previously removed.
CAUTION: Before starting installation,
disconnect the power by turning off the
circuit breaker or removing the fuse at the
fuse box. Turning power off using the fan
switch is not sufficient to prevent electric
shock.
x 10
13
4
5
Switch Housing
Mounting Ring
6
Switch Housing
Mounting Ring
Packing
Mount
Publicidad
