Publicidad
Idiomas disponibles
Idiomas disponibles
INITIAL INSTALLATION
4.
Remove the canopy bottom cover (C) from
the canopy (B) by turning the canopy
bottom cover (C) counterclockwise.
Remove the mounting bracket (A) from the
canopy (B) by loosening canopy mounting
screws a half turn from the screw head.
Next, turn the canopy (B) counterclockwise
to remove the mounting bracket (A) from
the canopy (B).
Secure mounting bracket (A) to outlet box
5.
(not included) using screws, lock washers
and flat washers provided with the outlet
box.
*NOTE: It is very important you use the
proper hardware when installing the
mounting bracket (A) as this will support
the fan.
IMPORTANT: If using the angle mount,
make sure open end of mounting bracket
(A) is installed facing the higher point of the
ceiling.
Remove the cotter pin (M) and clevis pin
6.
(N), and loosen the two collar set screws
from the fan motor assembly collar.
4
Canopy Mounting
Screw
5
6
Set Screw
8
Canopy Mounting
Screw
Lock Washers
Flat Washers
Outlet Box
Screws
Collar
Set Screw
Publicidad
