Publicidad
Idiomas disponibles
Idiomas disponibles
FINAL INSTALLATION
7.
Remove one of the three light kit mounting
screws (P) from the switch housing (G) and
loosen the other two light kit mounting
screws (P). (Do not remove.)
While holding the 20W LED light kit (H)
under the fan motor assembly (F), make
the 2-pin wire connections.
Place the key holes on the 20W LED light
kit (H) over the two mounting screws (P)
previously loosened from the switch housing
(G). Turn the 20W LED light kit (H) until the
20W LED light kit (H) locks in place at the
narrow section of the key holes. Secure by
tightening the two light kit mounting screws
(P) previously loosened and the one (P)
previously removed.
8.
Raise the glass shade (I) up against the 20W
LED light kit (H) and secure it to the fan by
turning the glass shade (I) clockwise until
snug. DO NOT OVERTIGHTEN.
9.
Install the pull chains and fobs (L) onto the
pull chains located in the switch housing (G).
7
8
9
14
Publicidad
