Pahlen Jet Swim Athlete Manual De Instrucciones página 15

Jet Swim Athlete
2. Installation for thick pool wall
Note!
Any reinforcement must never be closer than 50 mm to stainless steel material.
The pool wall must be pre-plastered before assembling the specific details.
2a. Thick pool wall with liner
(Bricks, thermoblock, concrete, etc.)
22
10
15
11
14
13
12
9
1. Make holes in the pool wall / mold and fix the enclosure (item 1).
The flange on the enclosure must be installed with the finished pool wall.
2. Connect the starter hose (item B) to the enclosure, see Section "3 Installing the starter
hose" on page 13.
3. Mount all the pipes (items 2– 4 ) in the enclosure. All threads must be sealed with thread
tape.
4. Cast (alternatively, masonry brick).
5. Attach the self-adhesive gasket (item 8) to the enclosure flange.
6. Mount the wall mat and liner.
7. Fill the pool with water up to 5 cm below the enclosure.
8. Screw (item 11) the fastening frame (item 10) with the rubber gasket (item 9) under-
neath the enclosure flange with 5Nm in tightening torque. The screws must be greased.
9. Cut off the liner against the inside of the mounting frame.
10. Mount the inlet grille (item 13) and the front (item 14). These screws (item 15) must also
be greased.
11. Connect the pump (item 19) with the supplied hose socket (item 16), hose (item 17)
and hose clamps (item 18). The pool can then be filled with water to the desired level.
12. Electrical connection must be carried out by a qualified electrical installer, see section
"Electrical installation".
NOTE! The pump must never run without water.
20
1
21
8
4
5 6
16
3
2
Figure 6.
Example A: Bricks with liner as seen from above.
Surface treatment
E
The tolerance class in accordance with this
part of ISO 2768-1
Tjockväggig pool med Liner
Jet Swim Athlete
Box 728, SE-194 27 Upplands Väsby, Sweden
Phone +46 8 59411050, Fax +46 8 59086880
15
ENGLISH
7
18
17
19
Designed by:
1. Niche
2. Casting pipes (suction)
Assembly drawing no.
3. Casting pipes (pressure)
4. Casting pipe start
5. O-ring
6. Plug
7. Starter hose (two parts)
8. Self-adhesive gasket
9. Packing
10. Mounting frame
11. Recessed screw M5x16 (24 pcs)
12. Screw M4x10 (8 pcs)
13. Inlet grille (3 parts)
14. Front
15. Recessed screw M5x20 (2 pcs)
16. Hose socket (2 pcs)
17. Hose (2 pcs)
18. Hose clamp (4 pcs)
19. Pump
20. Pool body (brick)
21. Wall mat
22. Liner
Drawn by: Date Approved b
RJ 2019-04-01
Art.no.
Scale Revised by
Drawing number
Vattennivå