cecotec DRUMFIT AB FIT PRO Manual De Instrucciones página 26

ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1. Main frame
2. Large handle
3. Pads
NOTE:
the graphics in this manual are schematic representations and may not exactly match the
device.
2. BEFORE USE
- This appliance is packaged in a way as to protect it during transport. Take the device out
of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the device when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
Box content
- Drumfit AB Fit Pro abs wheel
- Instruction manual
3. PRODUCT ASSEMBLY
1. The two ends of the large handle are placed in the holes of the wheel. When you hear a
"click" you will know that both ends are correctly positioned. Fig. 2
2. When attaching the pads, pay attention to the front and rear (grey side facing up). First
place them on the wheel to check the position (there is a difference in angle and direction).
3. When you are sure that the position is correct, remove the protective film and stick them
on the wheel. Fig. 3 and Fig. 4
4. The wheel is now ready for use. Fig. 5
26
DRUMFIT AB FIT PRO