Tesmed Trio 6.5 Manual De Instrucciones página 110

Power supply
Output channel
Wave sharp
Output voltage
Output current
DC capacity of output
Treatment time
Output intensity
Treatment mode
Number of treatment
program
Operating conditions
Transportation and
storage environment:
Dimensions
Weight
Automatic shutoff
Electrode detection
function
Output precision
Grade of waterproof
Electric shock
Applied part
Mode of operation
Device service life
Note: Not intended to be sterilized.
Not for use in an OXYGEN RICH ENVIRONMENT
4.2 Technical specification for TENS mode
P.W. (pulse width)
P.R. (Frequency)
Output characteristics
Tesmed copyright - it is absolutely forbidden the partial or total reproduction of any present content
DC3.7V/400mAh Polymer lithium battery (Built-in)
Dual, isolated between output channels
Bi-phase square-wave pulse
Max. 40Vpp (at 500ohm load)
Max. 80mA (at 500ohm load)
0
10-30 minutes
0 to 40 levels, adjustable
TENS, EMS and Massage
TENS: 12 programs;
EMS: 12 programs;
Massage: 12 programs
5°C-40°C (41.0°F-104°F) with a relative humidity of 30%RH-85%RH
5°C to 40°C with a relative humidity of 15%-93%, atmospheric
pressure from 700 hPa to 1060 hPa atmospheric 700hPa - 1060hPa
-10°C-50°C (14.0°F-122°F); 15%RH-90%RH, non-condensing
-25-55°C (-13-131°F); ≤95% RH;
700hPa – 1060hPa
110*60*16.2mm (L*W*H)
95g
3min.
The amplitude level will be reset to 0 V, when the amplitude level
is 1 or greater and an open circuit at either channel is detected.
All the output parameters allow ±20% error for the specification.
IP22
Internally powered ME equipment Internally powered ME II equipment
Type BF applied part, including the whole unit
Continuous operation
5
2 years (Normally)
80-300us
1-150Hz (Hz=vibration per second)
Constant Voltage (CV)
110
10