Citizen CT-S801 Manual De Usuario página 61

Switch no.
MSW10-1 Print Density
MSW10-2 Print Speed
MSW10-3 ACK Timing
MSW10-4 Old command
MSW10-5 Buzzer Event
MSW10-6 Buzzer Sound
MSW10-7
MSW10-8 LCD Direction
MSW13-1 Security/Target
MSW13-5 BT Device Scan
MSW13-6 Auto Reconnect
Notes:
*1: If print data is very dense, the print head is hot, data transmission is slow, or some other
conditions, the motor and printing may occasionally stop which causes white stripes in the
printout. To print high-density data, set MSW2-3 (Spool Print) to ON to reduce striping, although
this increases the time before printing starts.
For a serial interface, increase the transmission speed to prevent the motor from stopping.
*2: When density priority is set, the maximum print speed is 400 mm/second.
When high-speed priority is set, the maximum print speed is 500 mm/second.
Switching to high-speed priority may affect print quality. If readability or bar code reading accuracy is a
priority for your operations, return the setting to density priority.
Furthermore, from the start of printing until 1000 mm, printing is done at the maximum print speed of
500 mm/second, but from 1000 mm and further, the maximum print speed changes to 400 mm/
second.
*3: The values for memory switches MSW7-X are only effective when DIP switch no. 1 is set to OFF.
Function Initial setting
100 %
Level 9
Before Busy Before Busy, Same Period, After Busy
Invalid
Not by
C.Open
Tone 2
Key Lock Invalid
Normal
Low/All
Discoverable No Response, Discoverable
Valid
70 %, 75 %, 80 %, 85 %, 90 %, 95 %, 100 %, 105 %,
110 %, 115 %, 120 %, 125 %, 130 %, 135 %, 140 %
Level 1, Level 2, Level 3, Level 4, Level 5, Level 6,
Level 7, Level 8, Level 9
Invalid, CBM1, CBM2
All Event/Error, Not by C.Open, Not by C.Open/PE
Tone 1, Tone 2, Tone 3, Tone 4
Invalid, Valid
Normal, Inverted
Low/All, Mid/All, Mid/Paired only, Hi/All, Hi/Paired only
Invalid, Valid
— 57 —
Setting value