Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
Control Panel Setup
LOCK
Your remote controls will NOT work when LOCK
mode is active however your keyless entry will still
allow access to your garage.
Activate:
Press and hold the LOCK button for 2 seconds.
The command LED will flash as long as the lock
feature is activated and your handheld remote
control will not operate your door at this time.
Deactivate:
Press and hold the LOCK button again for 2
seconds. The command LED will stop flashing and
normal operation will resume.
LIGHT
To change the amount of time the garage door opener lights will stay on:
Press and hold the LOCK button until the garage door opener lights flash.* The time interval is
indicated by the number of flashes.
Number of times garage
door opener lights flash
1
2
3
4
To cycle through the time intervals repeat the step above.
* Approximately 10 seconds
Command LED
LOCK Button
Time the garage door opener light stays on
1-1/2 Minutes
2-1/2 Minutes
3-1/2 Minutes
4-1/2 Minutes
LIGHT FEATURE (Default is Active)
Deactivate:
Press and hold the LIGHT button until the garage
door opener lights turn on, then off again.*
Activate:
Start with the garage door opener lights on. Press
and hold the LIGHT button until the garage door
opener lights turn off, then on again.*
If the command LED is continuously blinking, the
LOCK feature needs to be deactivated.
MAINTENANCE ALERT SYSTEM (MAS):
Activate/Deactivate:
Press and hold the LEARN button. Then press the
LIGHT button. The service LED will flash the status;
Active is 2 flashes and deactivated is 3 flashes.
28
Command LED
LOCK Button
LIGHT Button
Service
LED
LEARN
Button
LIGHT
Button
Publicidad
