Descargar Imprimir esta página

LiftMaster myQ Business CAP2D Manual De Instalación página 7

Publicidad

Idiomas disponibles

Idiomas disponibles

INTRODUCTION
Wire Specifications
Use this chart to pull wires in preparation of your installation.
INTRODUCTION
DESCRIPTION OF WIRE RUN
Power Wire, secondary DC output
INTRODUCTION
Local Area Network (LAN)
CAT 5/6 Network Cable
Door Strike/LiftMaster Gate Operator
Magnetic Lock
Dry Contact Closure (Most Gate Operators)
INTRODUCTION
Exit Request (REX)
Supervised Input
Wiegand/Proximity Readers
NOTE: Main power supply and control wiring MUST be run in separate conduits. Conduits must be UL approved for low and high
INTRODUCTION
voltage. Refer to the NEC, ANSI/NFPA 70 for additional wiring requirements.
NOTE: Place the CAP2D unit within 500 feet of its associated electronic strike or latch. Monitoring Software is not UL evaluated.
Always provide power from a dedicated source. Plug provided transformer into an outlet wired to its own 10 Amp minimum circuit
breaker. This will prevent two problems:
INTRODUCTION
• Other equipment cannot introduce spikes, noise, surges or dips into the power circuit that will affect the system.
• The system's operation will not be affected if any other equipment develops a short circuit across the power line.
* CAT 5/6 NETWORK CABLE NOTES:
• For outdoor distances exceeding 140 feet (42.7 m), a UL497 compliant primary surge protector MUST be installed at
the controller.
• Distances exceeding 328 feet (100 m) can be accommodated with additional hardware. Contact Technical Support for more
information. Additional hardware was not evaluated under UL294.
PRE-INSTALL
WIRING
PRE-INSTALL
WIRING
PRE-INSTALL
WIRING
PRE-INSTALL
WIRING
PRE-INSTALL
WIRING
PRE-INSTALL
WIRING
NETWORK
NETWORK
WIRE SPECIFICATION
2-Conductor 14 AWG
2-Conductor 16 AWG
2-Conductor 18 AWG
NETWORK
8-Conductor, 24 AWG Twisted pair
2-Conductor 18-22 AWG Shielded
2-Conductor 18-22 AWG
2-Conductor 18-22 AWG Shielded
NETWORK
2-Conductor 18-22 AWG
2-Conductor 18-22 AWG
7-Conductor 18-22 AWG Shielded
NETWORK
NETWORK
7
ACCESS CONTROL
ACCESS CONTROL
MAXIMUM RUN DISTANCE
Up to 60 feet (18.3 m)
Up to 37 feet (11.3 m)
Up to 24 feet (7.3 m)
ACCESS CONTROL
328 feet* (100 m)
100 - 250 feet (30.5 - 76.2 m)
50 - 125 feet (15.2 - 38.1 m)
500 - 2500 feet (152.4 - 762 m)
ACCESS CONTROL
500 feet (152.4 m)
500 feet (152.4 m)
500 feet (152.4 m)
ACCESS CONTROL
ACCESS CONTROL
INSTALL
INSTALL
INSTALL
INSTALL
INSTALL
INSTALL

Publicidad

loading