LiftMaster myQ Business CAP2D Manual De Instalación página 8

INTRODUCTION
1
Internet Service
The controller MUST be configured with the proper network settings to operate.
INTRODUCTION
NETWORK
Internet service provider:
Automatic IP addressing: DHCP (default setting)
OR
INTRODUCTION
Static IP Addressing: Optional, requires connection to PC with USB (NOTE: Write down the following for future
reference: IP, Netmask, Gateway, Primary, Secondary, Server Port)
INTRODUCTION
2
CP# for Controller
(Located on a label on the housing)
INTRODUCTION
IPC - _ _ - _ _ _ _ _
3
Setup a myQ
NOTE: If you have an existing myQ
same password.
1. If you do not have a myQ® Business™ Account, call LiftMaster Customer Care and myQ
business account creation at 877-247-6764 to activate a myQ® Business™ Service
account.
2. You will get a welcome email from LiftMaster. Accept the email invitation and register or
login to your account.
3. Set up the Facility and add residents and credentials (refer to the available Help in myQ
4. Continue with the installation of the CAP2D in this manual.
PRE-INSTALL WIRING
PRE-INSTALL WIRING
PRE-INSTALL WIRING
PRE-INSTALL WIRING
PRE-INSTALL WIRING
Business™ Account
®
account, your myQ
®
For myQ Business™ programming please visit www.myqbusiness.com
®
NETWORK ACCESS CONTROL
NETWORK ACCESS CONTROL
NETWORK ACCESS CONTROL
NETWORK ACCESS CONTROL
NETWORK ACCESS CONTROL
IPC-XX-XXXXX
CP#
Business™ account will have the
®
8
INSTALL
INSTALL
INSTALL
INSTALL
INSTALL
Business™).
®