Craftsman 126.32563 Manual Del Operador página 19

CAUTION l
Dispose of the contents of the dust
collection bag in an environmentally
responsible way. It may be neccesary to
wear a dust mask when emptying the dust
collection bag.
INSTALLING THE HOLD DOWN CLAMP
(Fig. C)
Two sockets (one on either side) are
incorporated into the rear of the machine
fence.
1. Fit the clamp into the retaining socket that
best suits the cutting application, ensuring
that it is fully pushed down.
2. Tighten the fence thumbscrew to lock the
pillar of the Hold Down Clamp into the fence
socket.
3. Put the workpiece to be cut onto the saw
bed.
4. Adjust the clamp using the thumbscrew
and hand-wheel so that it securely holds the
workpiece to the saw bed. Ensure that the
clamp does not interfere with the blade path.
INSTALLING THE TABLE EXTENSION
ARMS
Extension arms are provided for the Right
Hand and Left Hand sides of the table. These
extension arms slide into holes machined at
either side of the machine base.
NOTE: The extension arms should be
pushed 'fully home' into the machine base.
Correct installation will require approximately
3 inches of the extension arm to slide into the
machine base.
(Fig. D)
(Fig. D)
Fasten the arm(s) into the base by tightening
the appropriate screw in the base of the
fence socket(s)
(Fig. C)
19