Descargar Imprimir esta página

Craftsman 126.32563 Manual Del Operador página 23

Publicidad

Idiomas disponibles

Idiomas disponibles

(Fig. M)
I'
3. If the blade is not 900 square with the miter
table, adjustment is required.
4. Loosen the Bevel Lock Handle and tilt the
Cutting Head to the left.
5. Loosen the Iocknut on the Bevel Angle
Adjustment Screw. (Fig. P)
(Fig. M)
2. Place a combination square on the miter
table with the rule against the table and the
heel of the square against the blade. (Fig. N)
(Fig. N)
(Note for illustrative purposes only the Cutting
Head has been removed from this diagram).
(Fig. P)
6. Use an Allen Key to turn the screw in or
out to adjust the blade angle.
7. Return the Cutting Head to its upright
position and recheck angular alignment
against the combination square.
8. Repeat steps 1 to 7 until correct angular
alignment is achieved.
9. Tighten the Bevel Angle Adjustment Screw
Iocknut securely.
23

Publicidad

loading