Publicidad
Idiomas disponibles
Idiomas disponibles
0° Bevel Pointer Adjustment
NOTE: The operator must be satisfied that
the blade is set exactly perpendicular
to the
table when in the upright position and against
its stop.
1. If the pointer is not in exact alignment
with the 0° mark on the protractor scale
adjustment is necessary.
2. Loosen the Bevel Pointer screw using a #2
Phillips screwdriver.
3. Adjust the Bevel Pointer so that it is in
alignment exactly with the 0° mark.
4. Retighten the screw.
450 Bevel Stop Adjustment
1. Loosen the Bevel Lock Handle and tilt the
Cutting Head completely to the left until it
rests against the 45 o stop.
2. Use a combination square to see if the
blade is at 45 oto the table.
3. If the saw blade is not in exact alignment
adjustment is necessary.
4. Return the Cutting Head to its upright
position.
5. Loosen the locknut on the 45 o Bevel
Adjustment Screw.
6. Use an Allen Key to turn the Adjustment
Screw in or out as required. (Fig. Q)
(Fig. Q)
7. Tilt the Cutting Head to the 450 setting and
recheck for alignment with the combination
square.
8. Repeat steps 1 to 7 until the correct
angular alignment is achieved.
9. Tighten the Adjustment Screw Iocknut
securely once alignment is achieved.
1_,
WARNING
I
When all angular adjustments
have been
successfully
completed, the operation of
the lower safety guard must be checked
to ensure that it is working
correctly.
The saw must not be used if the lower
safety guard is not operating correctly.
Fence Adjustment
The fence must be aligned at 90o (square)
to a correctly installed blade The rotary table
must be set at '0 °' miter angle.
The Fence is fastened to the table with
four (4) socket head Allen screws that are
positioned two (2) at either side in elongated
slots.
24
Publicidad
