Publicidad
Idiomas disponibles
Idiomas disponibles
Condition: The heat generator does not have an
option to connect it directly and/or is installed in the
wet environment.
▶
Remove the flap on the radio receiver
unit in accordance with the figure.
▶
Remove the existing cable for the direct
connection.
▶
Connect the eBUS cable, which is to be
provided on-site, in accordance with the
figure.
▶
Seal the flap on the radio receiver unit.
▶
Install the wall-mounting screws outside
of the wet environment in accordance
with the figure.
▶
Fit the radio receiver unit onto the wall-
mounting screws.
0020323648_01 Operating and installation instructions
6 0
m m
2,6 mm
▶
When opening the electronics box in the
heat generator, proceed as described in
the installation instructions for the heat
generator.
▶
Use an extension cable to connect the
radio receiver unit to the eBUS interface
in the heat generator's electronics box
in accordance with the figure. The LED
lights up green after 20 seconds at the
latest.
3.5 Installing the control
1.
Read the operating concept and the
operating example described in the
operating instructions for the control.
2.
Stand next to the radio receiver unit.
B
A
3.
Open the control's battery compart-
ment as shown in the figure.
4.
Insert the batteries, making sure that
the poles are the right way round.
◁
The installation assistant starts.
5.
Close the battery compartment.
6.
Select the language.
7.
Set the date.
8.
Set the time.
X24
X100
17
Publicidad
