SAKAWA AS6T Manual Usuario página 60

Problem Solving.
PROBLEMS
Failure to crack logs
If the pusher
logs moves sharply, makes
an unfamiliar noise, or
vibrates a lot
Oil leaks around the cylinder
or other points
Waste electrical equipment should not be disposed of with household waste, Please,
where recycling facilities exist, check with your local distributor or get advice for
recycling.
PROBABLE CAUSE
The trunk is incorrectly
positioned
Size or hardness of the
trunk exceeds machine
capacity
The edge of the blade
It's broken
Oil leaks
Unauthorized adjustment
on the Maximum Pressure
Limitation Screw. A lower
maximum pressure rating
was established.
Lack of hydraulic oil or air in
the hydraulic system.
Air locked in hydraulics
during work
The purge screw does not
is adjusted before moving the
chipper
The drain screw of
oil with dipstick is not
adjusted
Mounting valve
Hydraulic control and/or
seals used
60
POSSIBLE SOLUTION
See section
"Operate with a chipper" to
perfectly place the logs.
Reduce the size
before chipping the trunk
See section
"Wedge sharpening"
Locate leaks and
Contact the distributor
Contact the distributor
Check the oil level for
possible refilling. Contact the
distributor
Slightly loosen the
purge screw 3 or 4 turns
before working with the
chipper
Adjust the purge screw
before moving the chipper
Adjust
Contact your dealer