Optima Turn/English
(5).
Then turn on power switch to ON position.
CAUTION: The pump can only be applied to the mattress recommended
by the manufacturer. Do not use it for any other purpose. (Applied part:
air mattress) Do not position the equipment so that it is difficult to
operate the disconnecting device.
(6).
The cable management tape is provided along the side of the mattress to manage power
cable. Please make sure the wire has no signs of damage. After installation, extra length
of the power cord, if any, should be neatly managed to prevent stumble accident and
should be clear of moving bed mechanisms or other possible entrapment area.
NOTE: The EQUIPMENT should be firmly placed at position where
caregivers can access easily.
4. Operation
NOTE: Always read the operating instruction before use.
4.1. General Operation
(1). Switch the power on, the mattress starts the initial inflation. The Maxfirm light flashes until
the mattress is fully inflated which takes approximately 30 min.
(2). When the inflation is completed, the system will enter CLP mode for 10 minutes. If there
are no changes of modes, system will switch to Alternate Mode.
(3). Use the Pressure Adjustment key to get the correct setting of therapeutic pressure level
based on patient weight.
NOTE: Pressure levels with the weight guide on the panel is only an
indication and clinical judgement should always be taken into
consideration.
(4). For lateral turning, choose the Left-SUPINE-RIGHT turn key to get standard turning which
helps the patient to turn to both sides and back to supine position, or either one direction
in Left turn or Right turn mode.
NOTE: Do the hand check to check out if the pressure reduction is
adequate and the patient has not bottomed out.
NOTE: For patient comfort, always use the head pillow when patient is
under turning mode.
4.2. Emergency CPR Operation
NOTE: When there is a need to perform CPR
on the patient, quickly turn the CPR knob to
release air from mattress. CPR knob is
located at the right-head side of the mattress.
The quick connector on the pump unit can be
disconnected for even faster deflation.
9