BH FITNESS G152X Instrucciones De Montaje Y Utilización página 36

(106) Bolts M-10x65.
(107) Bolts M-10x70.
(108) Bolts M-10x75.
(109) Bolts M-10x80.
(110) Bolts M-10x85.
(111) Bolts M-10x95.
(112) Bolts M-10x100.
(113) Bolts M-10x105.
(114) Bolts M-12x75.
(115) Bolts M-12x135.
Fig.6
(117) Flat washers M-5.
(118) Flat washers M-8.
(119) Flat washers M-10.
(120) Washers M-10.
(121) Flat washers M-12.
(122) Flat washers 40x19,5.
(123) Flat washers 46x26.
(124) Flat washers 32x13.
(125) Self locking M-10.
(126) Self locking M-12.
(130) Washers M-8.
ASSEMBLY.-
1.-Place the main body (5) in the
upright position, as shown in Fig.7.
2.-Place the bases (3-4) onto the main
body (5), as shown in Fig.7, ensuring
the stickers on the left and right match
up, and tighten the screws (111).
3.-Fit the support leg (2) tightening the
bolts (112) against the rear plate Fig.8.
4.-Put the screws (112) into the screw
holes so that they are in their correct
position, without
Make sure the main structure (5)
remains in a vertical position Fig.8.
5.-Fit the top body (1) Fig.9 onto the
main body (5). inserting the tip of the
cable through the hole (M).Hand tighten
the nuts (125) as shown in Fig.9.
tightening Fig.8.
NOTE: Once this stage of the assembly
has been completed, all of the bolts
fitted should be retightened securely.
FITTING THE ABDOMINAL
SUPPORT.-
6.-Take the abdominal support (33)
and bolt it onto the main support (5),
using bolts (111) and washers (120) at
the top and the bolts (109) and
washers (120), as shown in Fig.10.
Remove the bolts from the front
support (10), Fig.10. Fit the front
support leg
handtightening all of the bolts (102)
along with their washers (120), Fig.10.
FITTING THE ABDOMINAL
ARMS.-
7.-Once the support (33) in step 6 of
these instructions has been fitted, take
hold of the
handtighten the bolts (106) onto the
support (33), Fig.11.
Next, take ther arms (36-37) and slot
them onto the tubes (34-35) in the
direction of the arrow, Fig.11, fit the
bolts and tighten securely, as well as
bolts (106) that were left handtight.
FITTING THE BUTTERFLY ARM
SUPPORT.-
8.- Fit the butterfly arm support (18)
into the top support (1), Fig.12. Insert
bolt (115), along with washer (121)
and nut (126), and tighten securely. Fit
the nut cap (73).
FITTING THE ARM LIMIT PLATE.-
9.-Take the nuts, washers and bolts
off the arm rotation support Fig.12.
Next, fit the plate (19) with the logo
facing outward and refit the bolts,
washers and nut. Tighten the bolts
securely.
36
(10) but
tubes (34-35)
only
and