Publicidad
Idiomas disponibles
Idiomas disponibles
Relative Mode (
This mode is used to zero out the display before measuring DC current. Press the "
to subtract out the non-zero number. Then, measure the DC amps. Pressing the "
again causes the "
"
" button for >2 sec. to exit this mode.
Selectable Auto Power Off (APO) Feature
The meter automatically powers itself down after about 30 minutes of no use. Press any
button, and the meter will wake up and display the last reading taken before power down. This
feature can be overridden by holding the Range (
from Off to any other position. When APO is defeated, the "APO" will be removed from the
display. Turning the meter off will restore the APO default.
Backlight
Press the
button in the middle of the meter to turn
the backlight on and off. The green backlight will remain
lit for about 4.5 minutes before it automatically turns off
to conserve battery power. Also, the TightSight™ bottom
display only lights while the meter is in the Amp function
to minimize battery drain.
Note: Backlight consumes 4x the battery power.
Measuring AC Current (Amps):
CORRECT
Single
Conductor
only
Note: 61-768 model also measures DC Current.
)
(61-768 model only)
" to flash and the original offset number to be displayed. Depress the
INCORRECT
Currents
) button while turning the function switch
H
N
cancel
Page 6
"button
" button
Backlight on in
all functions.
Backlight on
A
function
only
CORRECT
Use with
line splitter
Publicidad
