Trumpf TruTool S 160 Traduccion Del Manual De Instrucciones Originale página 17

3.1 Cutting clearance
a
Cutting clearance a = sheet thickness x 0.2
To set the cutting clearance, the moving cut-
ter blade must be in the lowest position. Only
loosen the fixed cutter blade enough to allow
it to be shifted without play, see Setting the
cutting clearance [} 282].
C
Cutting straight lines
Cutting curves
Cutting coils
3.3 Reducing the speed
With these power tools, the speed can be re-
duced quickly in the following situations:
– Cutting along scribed line
– Cutting radii
– Cutting high-tensile materials
1.0
Translation of the original operator's manual
3.2 Height regulator for moving
cutter blade
S 450
(3A1)
This TRUMPF shears offer the oppor-
tunity to adjust the immersion depth of the
moving cutter blade to the sheet thickness
and cutting task by using a height regulator.
The height regulator snaps in for full steps
and for the intermediate steps, see Setting
the moving cutter blade
Fig. 1: Height regulator for moving cutter
blade
Sheet thickness [mm]
1.5 2.0 2.5
[} 283].
D
3.0 3.5 4.0
EN
4.5
–
17