Abus FUBE50000 Manual De Instalación Y Usuario página 36

Installation and start-up
DIP switch layout
6. Adjust the DIP switch as required.
Factory /
Function
default setting*
1
2
3
4
5
6
7
8
 The "Permanent Status LEDs", "Permanent Key Lighting" and "Info and Alarm Tone
Sounds on the control device" functions are only available during operation with an
external power supply.
 For the "Info and Alarm Tone Sounds on the Control Device" and "Permanent Status LEDs"
functions, "Broadcast Panel Status" must be activated on the alarm control panel.
 "Info and alarm tone sounds on the control device" are only available if
"Permanent status LEDs" are set to ON.
 In order to use the chip key function, we recommend using an external 12 V power supply.
Although the use of this function is possible without an external power supply, this will make chip
key recognition slower and will shorten the wireless control device's battery life.
36
Permanent status LEDs
Backward compatibility
Battery operation
Info and alarm tone sounds
on the control device
Keypad tones
Chip key reader
Permanent keypad
lighting
Unused
OFF
The status of the sub-
areas is only displayed for
a few seconds during
operation*
FUAA50xxx*
Power supply unit
operation
(incl. batteries)*
No info or alarm tone sounds
on the control device*
Keypad tones deactivated*
Chip key reader
deactivated
Keypad lighting during
operation only*
(times out after 15 seconds)
-
ON
Permanent status LEDs
FU80xx
Battery operation
(without power supply unit)
Suppresses the status
message "Ext. PSU error"
on the alarm control panel
Info and alarm tone sounds
on the control device*
Keypad tones activated*
Chip key reader activated*
Permanent keypad lighting
-