Publicidad
Idiomas disponibles
Idiomas disponibles
I WARNING:
To avoid electric shock, disconnect the test leads from any
I
source of voltage before removing the battery door.
I
1.
2.
3.
4.
Disconnect the test leads from the meter.
Remove the protective rubber holster (if installed)_._t
_
Open the battery door by loosening the screw using a
Phillips head screwdriver.
Insert the battery into battery holder, observing the
correct polarity.
Put the battery door back in place. Secure with the
screw.
I WARNING:
To avoid electric shock, do not operate the meter until the
I
battery door is in place and fastened securely.
I
NOTE: If your meter does not work properly, check the fuses and batteries
to make sure that they are still good and that they are properly inserted.
Publicidad
