Removing The Headpiece From The Naída Ci Q30; Connecting The T-Mic 2/Earhook - Advanced Bionics CI Q30 Guia Del Usuario

Removing the Headpiece from the Naída CI Q30
Hold the cable's connector (the right-angled
plastic plug, not the wire).

Connecting the T-Mic 2/Earhook

Beginning with either the earhook or
T-Mic 2 disconnected, align the T-Mic 2
or earhook flush with the processor. Hold
the T-Mic 2 or earhook firmly at the top
and push towards the processor until it
meets flush with the processor.
Line up the pin with the hole in the T-Mic
2/Earhook and gently push it through
the hole. The pin will move from one side
of the processor, through the T-Mic 2/
Earhook, to the other, holding the T-Mic
2/Earhook in place. The pin should not
come out the other side.
18
Naída CI Q30 Sound Processor User Guide
1
1
3
2
Gently pull the cable's connector away
from the Naída CI.
2
Using the provided T-Mic 2/Earhook tool,
place one of the pins in the small hole on
the side of the tool. This will help to steady
the pin as you line it up with the pin hole
on the T-Mic 2/Earhook.
4
If a small portion of the pin extends
beyond the processor, use the side of the
tool to push the pin inward so it lies flush
with the processor.