Kohler K-R77748-SD-VS Instrucciones De Instalación página 5

1. Install the Faucet
Gasket
NOTE: Handle orientation is designed to be on the right.
Install the gasket to the faucet with the foam side down.
For Three-Hole Sinks: Place the escutcheon and undercover over the faucet holes.
Insert the faucet, with the handle on the right, through the escutcheon and the
mounting surface.
For Single-Hole Sinks: Insert the faucet through the mounting surface with the
handle on the right.
For thin gauge stainless steel sinks, consider installing a 1/2" (13 mm) plywood
support (not supplied) between the washer and the sink.
Slide the washer and ring over the hoses and wires and up to the shank.
Thread the ring onto the shank until the washer contacts the underside of the sink.
Adjust the ring to align the screws with the front and back of the faucet.
Securely tighten the screws.
Kohler Co.
Plywood
(Optional)
5
1/4"
(6 mm)
Ring
1433564-2-D