Publicidad
Idiomas disponibles
Idiomas disponibles
POLY-V BELT ASSEMBLY
MAKE CERTAIN the table saw is disconnected from
the power source.
Figure 6-1
B
A
C
.
Lay a straight (C) across the saw table (D) and
extension wing (E). Make sure that the front face of
the extension wing (F) is flat to the front face to the
main table (G). Adjust the extension wing so that its
top surface is exactly flat to the main table.
Securely tighten the four M8 X 30ram hex head
screws. See fig. 7-2.
Fig. 7-2
D
E
C
1.
Make sure all packaging material has been
removed from inside the cabinet.
2.
Open the motor cover and place the motor Poly-V
belt (A) over the blade pulley (B). See figure 6-1.
3.
Carefully lift the motor (C) and place the belt under
the motor pulley (not shown).
Make sure all the
v-notches in the belt are mated with the v-notches
of the blade and motor pulley. See figure 6-1.
4.
Carefully let the motor down and close motor cover.
EXTENSION
WING ASSEMBLY
.
.
Before installing the extension wings on the table
saw, thread the four M6 X 15ram set screws (A)
into the threaded holes in the wings.
Only screw
them in about 1/3 of the way for now. See fig. 7-1.
Using four M8 X 30mm hex head screws, four M8
lock washers, and four M8 flat washers (B), mount
one extension wing to the main table. Do not com-
pletely tighten hardware at this time.
Fig. 7-1
A
16
G
4.
Adjust the four set screws (A) until the edge of the
extension wing that is furthest away from the main
table is even with the straight edge.
NOTE: It may take several combinations of loosening
and/or tightening the set screws and mounting screws
to get the extension wing level with the main table.
5.
Repeat steps 1 through 4 for the remaining exten-
sion wing.
HANDWHEEL
ASSEMBLY
MAKE CERTAIN the table saw is disconnected from
the power source.
Figure 8-1
D
B
Publicidad
