Husqvarna T540XP Mark III Manual Del Usuario página 32

Note:
Other chainsaw models may not meet the
kickback requirements when equipped with the listed
guide bar and saw chain combinations.
We recommend only to use the listed guide bar and saw
chain combinations.
Kickback and guide bar nose radius
Guide bar
Length, in/cm Pitch, in
12/30
14/36 0.325 mini
16/41
The usable cutting length is usually 1 in less than the
nominal guide bar length.
Filing equipment and filing angles
Use a Husqvarna file gauge to sharpen the saw chain.
A Husqvarna file gauge makes sure that you get the
5/32 in /
SP21G
4.0 mm
32
Gauge, in/mm
0.043/1.1
0.025 in /
595 00 47-01
0.65 mm
Low kickback saw chain
A saw chain that is designated as Low kickback saw
chain, meets the low kickback requirement specified in
ANSI B175.1-2021.
Saw chain
Max. nose ra- Type
dius
Husqvarna
8T
SP21G
correct filing angles. The part numbers are given in the
table below.
If you are not sure how to identify the type of saw chain
on your product, refer to www.husqvarna.com for more
information.
30°
Length, drive
links (no.)
51
59
64
60° 0°
Low kickback
Yes
595 00 46-01
1792 - 007 -