Garant GMT35 Manual De Uso página 30

GARANT GMT35 Surface finishing machine
de
Select Chips
CE
2
PL
en
PO
*
cs
Cancel
1 Select the type of abrasive chips:
Ceramic (CE),
da
Plastic (PL),
Porcelain (PO),
User-defined (*)
Or create a new category.
es
2 Select a pre-defined abrasive chips form or create a new
special form.
3 Select a pre-defined abrasive chips size or create a new spe-
cial size.
fr
4 Load selection.
7.6.4. Perform separation
hr
Open the chip outlet before continuing
hu
it
ü Motor stopped.
1. Press separate.
2. Follow the instructions for the screen and for the section
"Concluding work [} Page 28]".
nl
3. Confirm separation process.
8. Settings
Settings
pl
General
Control Center
Compound Selection
Remote Update
ro
Shut Down
sl
30
3
3x5
Select
Manual Mode
2000 rpm
10 h
30 min
1
2
3
4
5
1  Adjust the screen
brightness
 Select the display lan-
guage
 Reset to factory set-
tings
 Display operating
hours
2 Check the status of indi-
vidual components, error
messages
3 Select, edit and create compounds
4
8.1. GENERAL
8.1.1. Adjust the screen brightness
Adjust the screen brightness using the slider or button.
8.1.2. System language
English
PB40
German
To load the desired display language, click on the respective flag.
8.1.3. Reset to factory settings
Performing a factory reset will delete all programs and
custom chips saved to the machine, and restore
default settings. This action can NOT be undone. Are
you sure you want to perform a factory reset?
Press Reset to factory settings then confirm.
4 Perform remote update
5 Switch off the surface fin-
ishing machine
1 Select the display language
1
2 Set the date/time
3 Display the operating hours
2
4 Adjust the screen brightness
5 Remote Update
3
4
5
100 %
Chinese Russian
Factory Reset
Factory Reset