Casada braintronics POLLUX Manual De Instrucciones página 59

Commissioning
Use the controller to recline the backrest to its lowest position,raise and extend the footrest to its top
•
position, make sure there is enough clearance before commissioning.
Return the backrest and footrest back to its default position after commissioning and turn off the
•
power switch.To choose the massage program, please check the Instructions of Control Panel and
Instructions of Touchscreen Controller for reference.
Before Sitting in the Chair
Ensure the footrest is well assembled before sitting on the massage chair.
•
Ensure the massage chair is returned to its original position before sitting on it.
•
If there is any part not in default position,please turn off the massage chair to allow it to restore.
•
Moving the Massage Chair
Roll the chair on its casters to the desired location.
•
Incline the backrest to upright position.
•
Turn off the power switch and unplug the appliance from the electrical outlet.
•
Using two people,push down on the backrest and lift up on the front side by grabbing the moving
•
Holder located to the front bottom of the armrest),roll the chair on its casters to the desired location(-
check the sketch for reference).
Do not take seat while the legrest is lifted.
•
Do not put excessive load on the legrest to avoid damage.
•
CAUTION
59