Korg M PS-10 Guia De Inicio Rapido página 7

MPS-10
- Introduction
6. TRIGGER IN CH A/B, TRIGGER IN CH C/D jacks
Connect commercially available drum pads or similar accessories to these jacks.
As these are stereo (TRS) jacks, you can use a stereo splitter cable or the like to separate the signals and connect
two drum pads.
7. FOOT SW 1, 2 jacks
Connect a Korg PS-1 or other foot switch here. You can assign functions to the pedal, such as looper start/stop.
8. EXPRESSION PEDAL jack
Connect a Korg XVP-20, EXP-2 expression pedal or similar pedal here. You can assign functions to the pedal,
such as looper volume adjustment.
Note: If you're using the pedal for the first time, calibrate the pedal. See the Owner's Manual (HTML) for details.
9. MIDI OUT connector
Use this to connect to an external sound generator or other MIDI device. Connect the MIDI OUT connector of
this unit to the MIDI IN connector of an external MIDI device, and use the pads of this instrument to play the
external MIDI device.
10. TO MEMORY DRIVE port
Connect a commercially available USB flash drive here. WAV files and setting data can be read and written to and
from the flash drive.
Make sure to format the USB flash drive on this unit before use.
Note: A USB flash drive with up to 2 TB capacity can be used. Some USB flash drives may not work with the MPS-10.
Note: Some USB flash drives may heat up when accessed at high speeds.
11. TO PC port
To exchange MIDI message data between the MPS-10 and your computer, connect the TO PC port of this unit to
your computer with a commercially available USB 2.0 cable. This port can also send and receive USB audio.
Connecting the AC adapter
1
Connect the DC plug of the included AC adapter to the DC 9V jack on the rear panel.
2
After connecting the DC plug, hook the AC adapter cord onto the cord hook.
Make sure to use the included AC adapter. Using a different AC adapter may cause a malfunction or
other issues.
Do not use excessive force when pulling the cord off the hook. Doing so may cause damage to the plug.
3
Connect the AC adapter to an AC outlet.
Be sure to use an AC outlet of the correct voltage for your AC adapter.
AC adapter
(included)
En-6