Num'axes CANICOM 5.500 LE Manual De Instrucciones página 27

● Checking/replacing battery of the receiver collar
To check the condition of the battery, observe the indicator light located on the front of the receiver collar:
- flashes slowly green: battery sufficiently charged
- flashes quickly red: weak battery. Be prepared to replace battery.
Replace the old battery with a new one (See § First use from new: Fitting the battery in the receiver collar) then
check the collar operates correctly.
● Changing the contact points
Two different series of contact points are supplied. The length of the contact points must be sufficient to have
proper contact with the dog's skin, enabling the device to operate correctly.
If you have a long-haired dog and the short contact points fitted to the collar in the factory are inadequate, remove
and replace them with the long ones supplied with the kit.
Carefully tighten them manually (do not use a key).
● How to check that your product is functioning properly
- Activate the receiver collar you want to test.
- Activate the remote control.
- Select the collar you want to test using the
on the LCD screen.
- Press the button on the remote control: the collar must emit beep sounds.
- Press the button on the remote control: the collar must vibrate.
- Put the all-in-one accessory in contact with the contact points located
on the collar (ref. Diagram 8) and press the
control: the test lamp inside the all-in-one accessory must light.
If you have several collars, renew the same procedure for each one.
Getting the best results
●
The training instructions you send to your dog are sent
from the remote control to the receiver collar by radio waves.
These radio waves are sensitive and the range reaches approximately:
- 500 meters for CANICOM 5.500 LE
- 1 000 meters for CANICOM 5.1000 LE
The range depends on geography and environment.
Gb - 27
or button of the remote control. The symbol
‹ ›
button on the remote
or appears
Diagram 8
Checking your product is
operating properly