Oase AquaMax Eco Expert 20000/12V Puesta En Marcha página 17

Connecting and disconnecting the OASE Control plug connection
NOTE
The unit will be damaged, if water enters the plug connector.
 Connect the plug connector or place the protective cap on it.
Ensure that the rubber seal is clean and fits exactly.

 If the rubber seal is damaged, it must be replaced. When the plug connector is disconnected,
the rubber seal must be replaced if it is older than 2 years.
 Always secure the plug connector or the protective cap with the two screws.
Submerged installation of the pump
Connecting
 B
Do not plug the power plug into the socket yet!
Installation
 C
• Place the pump horizontally on a stable surface.
• Ensure secure and stable positioning of the pump.
• For muddy or soiled water, we recommend installing the pump or intake-side components
(skimmer, satellite filter, base outlet, etc.) above ground level. This decreases intake of parti-
cles and increases the service life of the impeller unit.
• Only operate the pump when it is covered in at least 10 cm of water. Otherwise it may draw in
air.

The pull rope allows you to simply pull the pump from the water.
− Fasten the pull rope on the bottom filter casing through the round openings and make a
knot.
EN
PLX0004
AMX0074
17