Publicidad
Idiomas disponibles
Idiomas disponibles
APPLICATIONS
○ Cutting various types of wood.
○ Cutting aluminum sash.
REMOVAL AND INSTRUCTION METHOD
OF BATTERY OR AC/DC ADAPTER
○ How to install the battery or AC/DC adapter.
Align the battery or AC/DC adapter with the groove in
tool handle and slip it into place.
Always insert it all the way until it locks in place with a
little click, If not, it may accidentally fall out of the tool,
causing injury to you or someone around you (Fig. 8).
○ How to remove the battery or AC/DC adapter.
Withdraw battery or AC/DC adapter from the tool
handle while pressing the latch (2 pcs) of the battery
or AC/DC adapter (Fig. 8).
Pull out
Insert
Push
CHARGING METHOD
NOTE
Before plugging into the receptacle, make sure the
following points.
○ The power source voltage is stated on the nameplate.
○ The cord is not damaged.
WARNING
Do not charge at voltage higher than indicated
on the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn out.
ASSEMBLY AND OPERATION
Battery
Latch
Fig. 8
<UC18YSL3>
1. Connect the charger's power cord to a receptacle.
When the power cord is connected, the charge
indicator lamp will blink in red. (See Table 3)
WARNING
Do not use the electrical cord if damaged. Have it
repaired immediately.
2. Insert the battery to the battery charger.
Insert the battery into the battery charger as shown in
Fig. 9.
Charge
indicator lamp
3. Charging
When inserting a battery in the charger, charging will
commence and the charge indicator lamp will blink in
blue.
When the battery becomes fully recharged, the
charge indicator lamp will light up in green. (See
Table 3)
(1) Charge indicator lamp indication
The indications of the charge indicator lamp will be as
shown in Table 3, according to the condition of the
battery charger or the battery.
English
Battery
Guide rail
Fig. 9
17
Publicidad
