Publicidad
Idiomas disponibles
Idiomas disponibles
English
is plugged in while charging a USB device from the
battery, or if a rechargeable battery is inserted while
charging a USB device from the battery charger.
○ USB charging stops for five seconds so that checking
can be performed once the rechargeable battery has
been fully charged.
○ If the rechargeable battery level is extremely low,
charging the rechargeable battery takes priority, and
USB charging is temporarily stopped. USB charging
automatically resumes once the battery level has
reached a preset level.
PREPARATION BEFORE OPERATION
WARNING
Pull out battery before carrying out any
adjustment, servicing or maintenance.
When finished with a job, pull out the battery.
1. Power switch
Ensure that the switch is in the OFF position. If the
battery installed to power tool while the switch is in
the ON position, the power tool will start operating
immediately, which could cause a serious accident.
2. Remove all packing materials attached or connected
to the tool before attempting to operate it.
3. Installation
Attach the power tool to a level, horizontal work bench
in accordance with Fig. 12.
Select 5/16" (8 mm) diameter bolts suitable in length
for the thickness of the work bench. Bolt length
should be at least 1-9/16" (40 mm) plus the thickness
of the work bench.
For example, use 2-9/16" (65 mm) or larger bolts for a
1" (25 mm) thick work bench.
11/32" (9 mm)
4 holes
12-7/8"
(327 mm)
Miter lock handle side
20
11-1/18"
(282 mm)
Base
5/16" (8mm) bolt
Work bench
The holder attached to the rear of the base helps stabilize
the power tool.
Holder adjustment:
Loosen the 6 mm bolt with the 10 mm box wrench.
Adjust the holder until its bottom surface contacts the work
bench surface.
After adjustment, firmly tighten the 6 mm bolt.
Holder
Adjust the holder until its bottom surface
contacts the work bench surface.
4. Releasing the locking pin
When the power tool is prepared for shipping, its main
parts are secured by a locking pin.
Press the handle slightly down and pull out the
locking pin to disengag the cutting head.
During transport, lock the locking pin into the gear
case.
5/16" (8 mm) nut
Fig. 12
Move
6 mm Bolt
Fig. 13
Publicidad
