Metabo HPT C3612DRA Manual página 35

Fence
Ⓑ
(3) Setting to cut crown moldings at positions ① and ④
in Fig. 42 (see Fig. 47; tilt the head to the right):
○ Turn the turntable to the right and set the Miter Angle
as follows:
– For 45° type crown moldings: 35.3° ( mark)
– For 38° type crown moldings: 31.6° ( mark)
○ Tilt the head to the right and set the Bevel Angle as
follows:
– For 45° type crown moldings: 30° ( mark)
– For 38° type crown moldings: 33.9° ( mark)
○ Position the crown molding so that the upper surface
(Ⓑ in Fig. 41) contacts the fence as indicated Fig. 49.
(4) Setting to cut crown moldings at positions ② and ③
in Fig. 42 (see Fig. 48; tilt the head to the right):
○ Turn the turntable to the left and set the Miter Angle
as follows:
– For 45° type crown moldings: 35.3° ( mark)
– For 38° type crown moldings: 31.6° ( mark)
○ Tilt the head to the right and set the Bevel Angle as
follows:
– For 45° type crown moldings: 30° ( mark)
– For 38° type crown moldings: 33.9° ( mark)
○ Position the crown molding so that the lower surface
(Ⓐ in Fig. 41) contacts the fence as in Fig. 50.
Ⓐ
Table on base
Fig. 46
Head
Bevel angle scale
④
Miter angle scale
Fig. 47
Head
Bevel angle scale
Fence (B)
③
Base
Fig. 48
Fence
Ⓑ
Table on base
Fig. 49
English
①
Fence (A)
Base
Turntable
②
Miter angle scale
Turntable
Ⓐ
35