Metabo HPT C3612DRA Manual página 24

English
Turn
Hinge
Bottom surface of head section
2–3 mm
Workpiece
4. Confirmation for use of sub fence (A)
WARNING
When right bevel angle cutting, loosen the 6 mm
wing bolt, then slide the sub fence (A) outward
and remove it as shown in Fig. 19.
Failure to do so may result in the main body or
saw blade coming into contact with the sub
fence (A) and causing injury.
This power tool is equipped with a sub fence (A). In
the case of direct angle cutting and left bevel angle
cutting, use the sub fence (A). Then, you can realize
stable cutting of the material with a wide back face.
CAUTION
In the case of direct angle cutting and left bevel
angle cutting, slide inward to the position where
the sub fence (A) hits, and secure it with 6 mm
wing bolt. (as shown in Fig. 19)
24
Gear case
6 mm depth adjustment bolt
Fig. 18-b
Fig. 18-c
Mounting position of
the sub fence (A)
6 mm wing bolt
5. Confirmation for use of sub fence (B)
WARNING
When left bevel angle cutting, loosen the 6 mm
wing bolt, then slide the sub fence (B) outward,
as shown in Fig. 20.
Failure to do so may result in the main body or
saw blade coming into contact with the sub
fence (B) and causing injury.
This power tool is equipped with a sub fence (B). In
the case of direct angle cutting and right bevel angle
cutting, use the sub fence (B). Then, you can realize
stable cutting of the material with a wide back face.
CAUTION
In the case of direct angle cutting and right bevel
angle cutting, slide inward to the position where
the sub fence (B) hits, and secure it with 6 mm
wing bolt. (as shown in Fig. 20)
Sub fence (B)
Fence (B)
Sub fence (A)
Fence (A)
Fig. 19
Mounting position of
the sub fence (B)
6 mm wing bolt
Fig. 20