Metabo HPT C3612DRA Manual página 7

6. Never reach around the saw blade.
7. Never touch any moving parts, including the blade,
while the saw is in use.
8. Never remove any safety devices or blade guards;
use of the tool without them would be hazardous.
9. Never lock the lower guard; always confirm that it
slides smoothly before using the tool.
10. Never attempt to move a plugged-in or battery-in
POWER TOOL while your finger is on the starting
switch.
11. Never use the POWER TOOL if the starting switch
does not turn on and off properly.
12. Never use the POWER TOOL if the plastic housing or
the handle is cracked or deformed.
13. Never use the POWER TOOL near flammable liquids
or gases because sparking can cause an explosion.
14. Never clean plastic components with solvents
because the plastic may dissolve.
15. Never operate the saw unless all the blade guards are
in place.
16. Never raise the saw blade from the workpiece until it
has first come to a complete stop.
17. When slide cutting, never pull the handle toward the
operator, since this could cause the saw blade to kick
up from the workpiece. Always push the handle away
from the operator in a single, smooth motion.
18. Never place your limbs inside of the line next to
warning sign " " while the tool is being operated.
This may cause hazardous conditions.
19. Never use abrasive type blades on this saw.
20. Never expose to rain or use in damp locations.
21. Never cut ferrous metals or masonry.
22. Do not replace the LED light with a different type.
23. Do not stand in a line with the saw blade In front of the
machine. Always stand aside of the saw blade. This
protects your body against possible kickback. Keep
hands, fingers and arms away from the rotating saw
blade.
24. Do not cross your arms when operating the tool arm.
25. When the saw head is in the down position, never
release the hand that is gripping the handle.
Doing so could snap the saw head up, forcing the tool
to fall and possibly cause injury.
WARNING
FOR YOUR OWN SAFETY READ THIS INSTRUCTION
MANUAL BEFORE OPERATING THE CORDLESS
SLIDE COMPOUND MITER SAW
1. Make sure to securely hold the tool during operation.
Failure to do so can result in accidents or injuries.
(Fig. 1)
2. Always wear eye protection when using the slide
compound miter saw.
3. Always keep hands out of the path of the saw blade.
4. Never operate the saw without the guards in place.
5. Never perform any freehand operation with the slide
compound miter saw.
6. Never reach around the saw blade.
7. Always turn off tool and wait for saw blade to stop
before moving workpiece or changing settings.
8. Always disconnect the battery before changing blade
or servicing.
9. Saw blade diameter is 12" (305 mm).
10. No load speed is 4,000 /min (Auto Switch mode) /
3,200 /min (High Torque mode).
11. To reduce the risk of injury, return carriage to the full
rear position after each crosscut operation.
12. Do not use the product if the tool or the battery
terminals (battery mount) are deformed.
Installing the battery could cause a short circuit that
could result in smoke emission or ignition.
13. Keep the tool's terminals (battery mount) free of swarf
and dust.
○ Prior to use, make sure that swarf and dust have not
collected in the area of the terminals.
○ During use, try to avoid swarf or dust on the tool from
falling on the battery.
○ When suspending operation or after use, do not leave
the tool in an area where it may be exposed to falling
swarf or dust.
Doing so could cause a short circuit that could result
in smoke emission or ignition.
14. Always use the tool and battery at temperatures
between 23°F (-5°C) and 104°F (40°C).
English
Fig. 1
7